[arm-allstar] suppressing variables to SIP clients

[Patrick Perdue]

Didn't see this thread for a while...

I'm referring to the variables from app.rpt which are sent as text to my 
SIP clients every ten seconds or so, which shows all connected nodes, TX 
state, etc.


On 12/31/2019 12:15 PM, "Doug Crompton via ARM-allstar" wrote:
> Not sure what you are referring to "rtp variables"?  There is silence
> suppression/VAD that suppresses data transmission during silence.
> There is also RTP keep alives in seconds which by default I believe is set
> to 0 (no keep alives)  Also if you have NAT=yes there are NAT keep alives.
> The sip qualify command (qualify=yes) will show RTT times for established
> registration using "sip show peers" this could be causing continuous check
> also. If there is an open sip voice circuit then there is going to be
> constant data unless there is silence suppression.
>
>
> *73 Doug*
>
> *WA3DSP*
>
> *http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*
>
> On Tue, Dec 31, 2019 at 11:52 AM "Patrick Perdue via ARM-allstar" <
> arm-allstar at hamvoip.org> wrote:
>
>> Hello:
>>
>> I have enabled the SIP module and configured a few clients that I prefer
>> over Zoiper. Everything works well, except for the fact that I get all
>> the rpt variable output sent to my SIP clients every 10 seconds or so.
>> Is there any way to stop this?
>>
>>
>> _______________________________________________
>>
>> ARM-allstar mailing list
>> ARM-allstar at hamvoip.org
>> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>>
>> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>>
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org