[arm-allstar] Kenwood Repeater Interface

[John Morandi]

I had to build a cable to connect a TKR-850 to an RA-40. I am not sure 
what pin on the accessory connector you are using, but I had to program 
one of the AUXIO pins on the 25 pin connector to 'TOR' switching LOW 
when active. That provided the LOW going COR that was only active when 
proper PL was decoded. I don't know if that helps.. never messed with 
the TKR-840.

On 12/15/20 8:33 PM, "David McGough via ARM-allstar" wrote:
>
> TKR-840 or TKR-850 ??
>
>
>> On Tue, 15 Dec 2020, "Chris Viningre via ARM-allstar" wrote:
>>
>>> I just set up a Kenwood TKR-840. I made a cable to connect to my soundcard
>>> and everything is working fine. The problem is that the node is keying the
>>> repeater with the PL tone off. The repeater works fine by itself and will
>>> not transmit without the PL tone. I have the duplex setting at 2 and have
>>> tried the other settings? Are there any Kenwood folks that can put me in
>>> the right direction?
>>>
>>> Chris Viningre
>>> 70 W. Roadrunner
>>> Salt Flat, Texas 79847
>>> C:(915) 504-1510
>>> Website: ws5b.com <http://ws5b.com>
>>> chrisviningre at gmail.com
>>> chris at ws5b.com
>>> Ham Radio Call Sign: WS5B
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org