[arm-allstar] Getting Echolink to run at boot.

[Mark]

G'Day to all.

I have got Echolink up ans running on my allStar node per the 
instructions at https://hamvoip.org/#howtos

but when we have had a power outage the node or i have shifted the node 
and power returns, the node reboots but Eckolink isn't running.

I generally go in to the CLI client and input the command " module load 
chan_echolink.so " to get it running again.

  I remenber reading some where about putting a line of comand into 
something that is read at boot on the raspberry Pi but can not find it 
again.

I was wandering if something could be put in as a Cron job to get it 
running and what this would look like ?


Regards

Mark VK3EME

Bendigo Vic AU

node 44099



-- 
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus