[arm-allstar] announcements resetting to default after reboot

[Russell Thomas]

not sure what i've done to the node. I had set the telemdefault=1 from a 2
and it seemed to run fine after this email but at some point today
telemetry is stopping in the middle of voice announcements and leaving the
ptt keyed up for what appears like indefinatly.
the only way i've found to fix it (I hope) is to turn off telemetry like
this:
telemdefault=0
any ideas what could be wrong?



On Thu, Oct 3, 2019 at 3:59 PM David McGough <kb4fxc at inttek.net> wrote:

>
> Nothing has recently changed regarding telemetry announcements, as far as
> I know??
>
> To turn telemetry on when Asterisk starts, in the rpt.conf node
> stanza, set:
>
> telemdefault=1
>
> Also note the telemdynamic statement, which allows user control via COP
> commands. To allow COP (such as 901, 902, 903) control commands:
>
> telemdynamic=1
>
>
>
> 73, David KB4FXC
>
>
>
> On Thu, 3 Oct 2019, "Russell Thomas via ARM-allstar" wrote:
>
> > I think this started happening after the last update.
> >
> > if I reboot my node (which isn't often) I have to run this dtmf code to
> > turn back on my announcements: *901
> >
> > *901 ; announce everything
> > *902 ; announce NOTHING
> > *903 ; announce for a few minutes then go quiet
> >
> > is this something that can be fixed?
> > or should I set this as a macro on bootup like where I connect to a node
> on
> > startup?
> >
> > 73,
> > Russell, KV4S
> > _______________________________________________
> >
> > ARM-allstar mailing list
> > ARM-allstar at hamvoip.org
> > http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> >
> > Visit the BBB and RPi2/3 web page - http://hamvoip.org
> >
>
>