[arm-allstar] suppressing variables to SIP clients

[Doug Crompton]

Not sure what you are referring to "rtp variables"?  There is silence
suppression/VAD that suppresses data transmission during silence.
There is also RTP keep alives in seconds which by default I believe is set
to 0 (no keep alives)  Also if you have NAT=yes there are NAT keep alives.
The sip qualify command (qualify=yes) will show RTT times for established
registration using "sip show peers" this could be causing continuous check
also. If there is an open sip voice circuit then there is going to be
constant data unless there is silence suppression.


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*

On Tue, Dec 31, 2019 at 11:52 AM "Patrick Perdue via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> Hello:
>
> I have enabled the SIP module and configured a few clients that I prefer
> over Zoiper. Everything works well, except for the fact that I get all
> the rpt variable output sent to my SIP clients every 10 seconds or so.
> Is there any way to stop this?
>
>
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>