[arm-allstar] Quantar 900 MHz Tx audio problem

[Clint (WB3EHB)]

Quick question,
Are you utilizing wide band audio on the repeater and as well as on your mobile and/or portables? or are you utilizing narrow band audio on the repeater and wide band audio on the mobile and/or portable?



IRLP Node's 3740 & 4546
WB3EHB at yahoo.com 

    On Sunday, August 11, 2019, 02:21:52 PM EDT, Doug Crompton via ARM-allstar <arm-allstar at hamvoip.org> wrote:  
 
 Roger,

  From what you are saying this is a problem in the radio?  What FOB's are
you using? Since it is happening in two different situations I would
suspect it is something in the radios. Maybe others can comment. You are
setting and saving the settings in simpleusb-tune-menu correct? If you
don't save it a restart or reboot will put you back where you were prior to
setting.


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*

On Sun, Aug 11, 2019 at 2:17 PM "Roger Coudé via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> We use Motorola Quantar 900 MHz repeaters at two locations (Nodes 47646
> and  47655) each with a hamvoip RPI system.
> Everything works fine, but after a few minutes of conversation, the TX
> audio gain suddenly  increases a lot (quite an annoying situation).
> Both repeaters behave like that.
> Is there a setting in the Motorola or whatever config that can prevent
> that?
> 73
> Roger VE2DBE
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
_______________________________________________

ARM-allstar mailing list
ARM-allstar at hamvoip.org
http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar

Visit the BBB and RPi2/3 web page - http://hamvoip.org