[arm-allstar] Error messages on receive

[Doug Crompton]

Happy to report this was resolved and Larry is a happy new Allstar user.
Welcome to Allstar Larry!

The basic problem was improper settings in simpleusb-tune-menu and RF
feedback from the antenna.

In certain situations it is easier to resolve things on the phone, via
teamviewer, or ssh. I am happy to do that as it actually takes less time in
most cases than back and forth via email!


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*



On Mon, May 7, 2018 at 11:11 AM, "Larry Moyer via arm-allstar" <
arm-allstar at hamvoip.org> wrote:

> After a couple of days of attempting to get my node operational I must
> admit defeat. The node registers, I can enter DTMF commands and the only
> response is a series of tones accompanied by multiple error messages as
> shown in the following image. I verified that the DTMF entries are
> correctly being read by the node.  Also, upon power up of the node a series
> of what I would think to be messages are received in the same manner: tones
> and error messages. I cannot say for sure if I have ever received human
> voice related to the node since the frequency may have been shared. The
> quality of the brief transmission suggested that it was not AllStar
> related.
>
>
>
>
>
> Thank you for any assistance.
>
> Larry Moyer, K5IMO
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>