[arm-allstar] Followup to “Registration fails (Doug Crompton)”

[Doug Crompton]

Please give us more information about your setup? Are you using a wired
ethernet connection? Can you ping ucsd.edu as a test? You need access to
the internet to register. You do NOT need any port forwarding for your node
to register and work outbound. A wrong port forward could screw things up
and not allow either in or outbound. Take out any port forwarding.

Is this a first time installation? Do you have other nodes?


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*


On Sat, May 5, 2018 at 7:53 PM, "Larry Moyer via arm-allstar" <
arm-allstar at hamvoip.org> wrote:

> Doug,
>
> I ran into the same problem last night and waited until today to post,
> giving me time to eliminate any variable I could think of.  I have
> exhausted my resources. The check_reg.sh says that the IP address
> (unregistered) is Unregistered and the DNS lookup returns. — ER1NOT FOUND.
> The router shows the wireless connection is there and the port in place.
> The router cannot ping the RPI.  The wireless access points are correctly
> configured in the RPI.
>
> Thank you,
>
> Larry Moyer, K5IMO
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org