[arm-allstar] alinco dr-x35t/e uri

[gregory]

Hello Everyone,
    i changed my radio from a kenwook tm-v71a to an alinco dr-435t/e.
the system worked great with the kenwood. after hooking up the alinco
cod and ptt works fine but the tx and rx audio is so low i thought it
wasnt working. after maxing out the tx rx settings to 900 you can just
barely and i mean barely hear the tx and rx audio, it sound clear but
the base station radio has to go full blast to hear the audio and then
the room has to be perfectly quiet. its hard to hear the audio over the
volumes being maxed out everywhere but if i listen carefully i can hear
the repeater id clearly. any ideas? i have tx set to 900 rx to 900 with
rxboost enabled. also when the radio recieves a transmission the audio
is too low for anyone to noticed it, everyone thinks its just a carrier
and asterisk doesnt see dtmf as well.

Gregory