[arm-allstar] Registered But can't Connect

[Doug Crompton]

First of all you have the ability to check all this locally. Everyone seems
to depend on what shows on allstarlink.org which really isn't a good check.
You can do all this checking locally.

At the Linux prompt (menu item 10) do -

check_reg.sh

It should give info about your registration

also

dns-query node   -  where node is your node number.

Assuming you really are registered as soon in the above commands go into
the asterisk client (menu item 12)  key your node radio and see that all
the DTMF digits are decoded. If not exit that and go into menu item 13
simpleusb-tune-menu and check your levels item 2 is most important. Talking
into your node radio should show 4-5 khz on bar graph.

You can also manually connect in the client  -  rpt fun your-node
*3destination-node

When you do that it will show information about the connect or error
messages if it does not connect.

If none of this works pass on the results of the above and we can explore
further.


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*

On Wed, May 2, 2018 at 6:52 AM, "Del James Beauchamp via arm-allstar" <
arm-allstar at hamvoip.org> wrote:

> Have node created shows registered, green on system wide nodes, shows in
> connected nodes list but can't link to other nodes or call into this node.
> Indicates congestion?
> Any ideas?
>
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>