[arm-allstar] Moto Acc. programming

[Doug Crompton]

Please keep in mind that carrierfrom or cosfrom and ctcssfrom have no real
meaning other than they monitor I/O pin inputs. On the DMK URI carrierfrom
is pin 8 and ctcssfrom is pin 7. You can use one or the other but when just
using one it is suggested to use carrierfrom pin 8.  Again this has no
bearing on whether it is carrier squelch or ctcss. It is just a input bit
which indicates an RX signal. There are situations where you could use both
but it is not the usual case. These bits are reflected in the
simpleusb-tune-menu 'V' option which shows the status of the bits and the
composite value.  When the node radio is receiving it shows keyed and when
not clear.


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*



On Mon, Jun 4, 2018 at 2:26 PM, "Robert Prybyzerski via arm-allstar" <
arm-allstar at hamvoip.org> wrote:

> I have an example of my setup here.  http://www.qsl.net/w2ymm/cdm_rim.html
> In simpleusb.conf
> carrierfrom=no
> ctcssfrom=usb
>
> That should get you going.
> It is the option #2 method described in the schematic
>
>
>
> Sent from my iPhone
> Bob W2YMM
> 631-960-1051
>
> > On Jun 4, 2018, at 12:40 PM, Tim Webb via arm-allstar <
> arm-allstar at hamvoip.org> wrote:
> >
> > Sorry folks but everything is starting to run together on me now. I'm
> still trying to understand AllStar.  I'm using a RBUSB RIM Lite Maxtrac,
> RPi2, & Moto GM300 simplex node. While listening on my HT the gm300 is
> retransmitting traffic from the East Coast reflector fine but is not
> passing my local traffic back to the reflector. The gm300 is showing that
> it is receiving from my HT but it's not keying the RIM to pass me to the
> reflector. When I go to the simpleusb-tune-menu #2 I get no RX Voice Level.
> I have programed the GM300 pin 8 to but can find the article that told the
> acc plug programming. I know there was another pin that needed programmed
> but can't find it now. Does anyone have a link or suggestion where to look
> for this setting. Under rpt.conf I have "Repeater/Simplex Node Settings"
> DUPLEX 1,  I don't know if this is my problem but will get me started
> anyway. Thanks for all of the help and understanding.
> >
> > 73
> > Tim Webb - KK4WH606.909.2094
> > www.facebook.com/kentucky220
> >
> >
> > _______________________________________________
> >
> > arm-allstar mailing list
> > arm-allstar at hamvoip.org
> > http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> >
> > Visit the BBB and RPi2/3 web page - http://hamvoip.org
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>