[arm-allstar] MABEL DR-1X Control Board Kit

[wadeoestreich]

MABEL should run on the RPi2 without issue. I believe the RPi3 was used 
because it was the newest of the bunch.


Wade - KC0MLT


On 02/16/2018 02:45 AM, "Larry via arm-allstar" wrote:
> Anyone have any experience using the MABEL DR-1X Control Board Kit 
> from http://www.customcomms.net/products
> Sounds quite interesting.
>
> It says it runs on a RPi3 with HamVOIP ver. 1.5 release which will run 
> Allstar and the Controller software programs.
> Just wondered if there were any known pitfalls.
>
> Also ...since the HamVOIP ver. 1.5 release will run on the RPi2 will 
> it run Mable also or is the RPi2-B lacking something?
>
> Larry - N7FM
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org