[arm-allstar] "Permanent" Linking

[Doug Crompton]

Bill,

 I do this all the time here. You need to connect using a startup marco.
Either end can do it but obviously not both. You decide which end is the
master so to speak. The startup macro would connect using *73xxxxx  I have
many local and remote nodes I want connected all the time and this works
well for me. If the primary (master) end goes down or reboots it
automatically reconnects. If the remote end goes down or anything in
between the master end will attempt reconnects until it can connect again.
A commented startup_macro line is in rpt.conf


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*



On Thu, Nov 9, 2017 at 11:51 AM, "William Freeman via arm-allstar" <
arm-allstar at hamvoip.org> wrote:

> I apologize for a second e-mail immediately after my other one; however, I
> wanted to keep this streamlined for archive purposes.
>
> How do I go about setting up a permanent-type link? What I am after is
> setting up my repeater, 42631, to automatically reconnect to my simplex
> node, 41394. in the event it gets disconnected for a whole slew of reasons.
>
> Thanks, again.
>
> Bill N4NJJ
>
> --
> William Freeman
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>