[arm-allstar] Feature request for single shutdown and boot gpio setup button switch.

kd4ont kd4ont at yahoo.com
Tue Jul 11 02:36:23 EST 2017


Damned spell check on phones! You get my gist.

-------- Original message --------
From: kd4ont via arm-allstar <arm-allstar at hamvoip.org> 
Date: 07/11/2017  03:28  (GMT-05:00) 
To: arm-allstar at hamvoip.org 
Cc: kd4ont <kd4ont at yahoo.com> 
Subject: [arm-allstar] Feature request for single shutdown and boot gpio
  setup button switch. 

I found, through lots of digging, that there is a default boot switch, with the gpio, with rp3. The suggested shutdown pin config, uses different pins. In my setup, I had to change the gpio pins to have two switches. I am not a python programmer yet. Could an update change this so that one pair of gpio and ground, if held for 6 seconds or less would make a graveful shutdown, yet, if the pi is off, a quick press would tell it to boot? This woukd free up a pair of pins and have less hardware to do the same thing. It would act just like a pc with a single power button. It seems more efficient to me. 
I don't know how many users might think this is a good feature request. One less hardware button. One less hardware software config. Just trying to think of streamlining ideas...
_______________________________________________

arm-allstar mailing list
arm-allstar at hamvoip.org
http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar

Visit the BBB and RPi2/3 web page - http://hamvoip.org


More information about the arm-allstar mailing list