[arm-allstar] Tring to add a second node to server and getting this erro message Device usb2 currently not active

[Doug Crompton]

Herman,

  You are using the right instructions. Did you uncomment and configure the
second section of simpleusb.conf? It is uncommented by default. Whatever
the context in simpleusb.conf is called the rxchannel= has to match. For
instance

rxchannel = SimpleUSB/usb2     << in second node of rpt.conf

Second section of simpleusb.conf - note - see how the lines are uncommented
- semicolons removed for lines needed.

 [usb2]
; Alinco DR135, DR235, DR435 Transceivers
eeprom=0
hdwtype=0
rxboost=1
carrierfrom=usbinvert
ctcssfrom=no
txmixa=voice
txmixb=no
invertptt=0
duplex=1
plfilter=yes
;deemphasis=no
;preemphasis=no
;rxaudiodelay=0



*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*

On Sun, Jan 8, 2017 at 6:51 PM, "Herman Pang via arm-allstar" <
arm-allstar at hamvoip.org> wrote:

> Trying to set up a second radio node on a RPI3 using the instructions found
> on "Page 10 of 12 - Beagle Bone Black Configuration How-to - 04/19/15 -
> WA3DSP"
>
> and getting this error message
>
>
>
> " Device usb2 currently not active"
>
>
>
> and do not see the expected message
>
>
>
> "Saved radio tuning settings to simpleusb_tune_usb2.conf"
>
>
>
> Using 2 DMK URI Fobs.
>
>
>
>
>
> Herman
>
> N6HHP
>
>
>
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>
>