[arm-allstar] No SSH

[Bryan St Clair]

A few ideas for remote diag:

Can you confirm the IP address of the node hasn't changed (internal) via
the router?

Can you set a DMZ to that IP and try the default and custom ports for SSH?

Just a couple ideas, for remote recovery.

Bryan


On Jan 3, 2017 08:10, Robert Newberry via arm-allstar <
arm-allstar at hamvoip.org> wrote:

I am going to be heading to one of my sites that is about an hour away. I
am using a RPI3 using the hamvoip image. I am hardwired to my router and
this configuration has worked just dandy for over a year. I needed to ssh
into my node and I get no response like the node isn't answering me.

I have not changed anything.

I reset the RPI using a power cycle on my ethernet power switch.

I reset the router. I also checked my portable forward rules.

The node works and functions like there is no problem. Except no SSH.

I am going to head to the site so I can look from a local monitor and look
at my ssh configuration.

Anyone got any suggestions or test I should run while on site?


N1XBM
Apparare Scientor
Paratus Communicare
Allstar Node # 27086, 41540, 41812, 42086, 42658, 42657
www.radioguysrepeaternetwork.com
_______________________________________________

arm-allstar mailing list
arm-allstar at hamvoip.org
http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar

Visit the BBB and RPi2/3 web page - http://hamvoip.org