[arm-allstar] Echolink permit list

[Justin Reed]

Doug,

Thank you. I think a limit of 50 would probably be plenty for my 
particular case.

73,
Justin
NV8Q


On 2/6/2017 11:43 AM, "Doug Crompton via arm-allstar" wrote:
> Justin,
>
>     Yes there is a limit. That was something that may have been overlooked
> as we did know about it.  I think it can be made larger. If so there will
> be an update.
>
>
>
> *73 Doug*
>
> *WA3DSP*
>
> *http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*
>
> On Mon, Feb 6, 2017 at 11:59 AM, "Justin Reed via arm-allstar" <
> arm-allstar at hamvoip.org> wrote:
>
>> Group,
>>
>> Is there a maximum number of callsigns that are allowed in the permit=
>> list within echolink.conf?
>>
>> On my node, I don't want it open to the whole world, I'd like to add users
>> upon request. I anticipate perhaps 30 total users.
>>
>> If I have just a few callsigns in the list, it works OK. If I put in, say,
>> 15 callsigns, then for some reason when I try to connect to Echolink it
>> connects and then disconnects within a few seconds. The CLI shows RTCP
>> timeout as the reason for disconnect.
>>
>> I'm using permit=n1xxx,n2xxx,n3,xxx,n4xxx...  format for adding callsigns.
>>
>> Thanks,
>> Justin
>>
>> NV8Q
>> 42640
>>
>>
>> _______________________________________________
>>
>> arm-allstar mailing list
>> arm-allstar at hamvoip.org
>> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>>
>> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>>
>>
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org