[arm-allstar] New Pi Config with Zoiper

[Doug Crompton]

Jeremy,

  You say it said connected to 41764. Is that not the correct node number?
What number should it be? Do you have a working node with a radio? Can you
connect to it with iaxrpt? Is this a Pi running V1.5 code? Did you run the
initial setup at first boot?

Your node number can be seen in several ways -

In /etc/asterisk/rpt.conf  - the first stanza a few lines down has your
node number in brackets [xxxxxx]
In /etc/asterisK/iax.conf scroll down to the registration line - it will
have your node number followed by a colon and your node (6 digit) password

if you type   echo $NODE1     at the Linux prompt it will show your node
number.

If your object is to connect with a phone and you are Android I would
recommend Android iaxrpt rather that zoiper, In either case see the howto's
on the hamvoip.org web page on both zopier and iaxrpt.


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*




On Thu, Dec 28, 2017 at 11:11 PM, "Jeremy Mathis via arm-allstar" <
arm-allstar at hamvoip.org> wrote:

> Hello all,
> I have my Pi set up, probably incorrectly, but we'll see. So I have my node
> number configured in it, and I followed the instructions from the PDF about
> setting it up to work with Zoiper. My phone connects to the node, but the
> message I get is "Node number 41764, Connected". I changed all the node
> numbers from that node to my own node number, restarted the Asterisk
> Server, then rebooted the Pi after that didn't work.
>
> I ran "grep 41764 *" from within /etc/asterisk and there are no results so
> I am at a loss as to what's up here. Any ideas what my next steps should
> be? Thank you.
>
> Jeremy Mathis
> ns7r
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>