[arm-allstar] Volume adjustments on Motorola GR1225

[LaRoy McCann]

Clint,
I used pin 11 for the receive audio to the uri.
I am feeding audio to pin 2 from the uri.

LaRoy McCann - K5TW


On 9/15/2016 7:18 PM, Clint (WB3EHB) wrote:
> Leroy,
>
> Please indicate whih pin you are using off of the transceiver 
> interface (16 pin connection)???
> Clint
> WB3EHB
>
> DMR ID.. 3134022
>
> AllStar Node 27631
>   
> IRLP Node's 3740 & 4546
> WB3EHB at yahoo.com
>
>
> On Thursday, September 15, 2016 5:40 PM, LaRoy McCann via arm-allstar 
> <arm-allstar at hamvoip.org> wrote:
>
>
>
>
>     I have a GR1225 repeater that I acquired.  It was a functioning
>     standalone repeater.
>     I now have it connected to a Pi and working.
>
>     The audio from the radio sounds great but the issue is with the
>     amount
>     of volume I am getting from the reciever.
>     I still peak over 5kc in simpleusb-tune-menu on loud voice peaks, and
>     that is with a Bofeng ht.
>
>     I have rxboost set to 0 in simpleusb.conf.  I am down to 10 on the
>     receiver adjustment of simpleusb-tune-menu.
>     All this and the audio is still a little hot.
>
>     This is the first gr1225 I have played with.  I am not sure about the
>     settings in the radio.
>     The Rx Audio Output is set to flat.
>     Operation Mode is set to Repeater w/Ext Controller.
>     Repeater Audio Mode is set to EIA.
>
>     There is a setting on the service menu, some type of gain setting
>     (don't
>     remember exactly what it was called) that went from 0-31. This was
>     set to 4.
>
>     Is there any other setting I am missing that would turn down the
>     volume?
>     Is there any pot adjustment in the radio?
>
>     Do I need to add a resistor or pot in the audio line to adjust the
>     level?
>
>
>     LaRoy  McCann - K5TW
>
>
>
>     ---
>     This email has been checked for viruses by Avast antivirus software.
>     https://www.avast.com/antivirus
>
>     _______________________________________________
>
>     arm-allstar mailing list
>     arm-allstar at hamvoip.org <mailto:arm-allstar at hamvoip.org>
>     http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
>     Visit the BBB and RPi2 web page - http://hamvoip.org
>     <http://hamvoip.org/>
>
>
>
> -- 
> This message has been scanned for viruses and
> dangerous content by the *DTISP MailScanner* <http://www.dtisp.com/>, 
> and is
> believed to be clean. 




---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.hamvoip.org/pipermail/arm-allstar/attachments/20160916/9c637e3a/attachment-0001.html>