[arm-allstar] More on Zoiper on the iphone

[Doug Crompton]

Tom,

Glad to hear you got it going.

 Near as I can tell that command was picked up in Asterisk 1.6 BUT it apparently only works on d/a or a/d conversions so even if it were available it would not work in most cases for Allsar. 
73 Doug
WA3DSP
http://www.crompton.com/hamradio


To: arm-allstar at hamvoip.org
Date: Sat, 10 Sep 2016 11:55:48 -0500
Subject: [arm-allstar] More on Zoiper on the iphone
From: arm-allstar at hamvoip.org
CC: tomw at ecpi.com

I was able to finally get Zoiper to properly register with my Allstar node – the final piece of the puzzle was to change the iax.conf “host=” line to dynamic as the example code had to start with.   Got confused thinking this should be an actual IP address given it was a public static IP address – that was WRONG! Still wishing I could raise the volume on the iPhone Zoiper app in speaker mode…  (Not an issue with Bluetooth car usage.)  This link gives an example of adding a volume statement to the dial definition in extensions.conf: http://www.withsupport.co.uk/wiki/increasing-sip-volume-freepbxasteriskelastixtrixbox exten => s,1,Set(VOLUME(TX)=4)            ;can be any integer from 0 to 10exten => s,1,Set(VOLUME(RX)=4)            ;can be any integer from 0 to 10 Tried that but with asterisk –rvvv monitoring, it reports “VOLUME not registered” so looks like this is not supported in our version. Any ideas on this? Tom N5TW  
_______________________________________________

arm-allstar mailing list
arm-allstar at hamvoip.org
http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar

Visit the BBB and RPi2 web page - http://hamvoip.org 		 	   		  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.hamvoip.org/pipermail/arm-allstar/attachments/20160910/e49f8074/attachment.html>