[arm-allstar] Allstar setup for RC210 Controller

[Charles Moore]

I made node 43801 using a Pi3 and URI.  It is connected to port 3 of an
Arcom RC210 Controller.  The Controller is on the W9LKI repeater 147.105
and the system is fully functional for a long time.  I can SSH into the
node.  I can connect to 43801 using my personal node 42119 and it shows
connected on the Allstar Node Stats page.  I used simpleusb-tune-menu item
2 to set the level as I have on other nodes I have built.  When I try to
DTMF or Voice call into the repeater it is not heard (meaning *3----
connect) or seen on the CLI.  Activity by other nodes elicits a response on
the CLI when they are connected.

The simpleusb.conf is set up as follows

eeprom=0
hwtype=0
rxboost=0
carrierfrom=usbinvert
ctcssfrom=no
txmixa=composite
txmixb=composite
invertptt=0
duplex=1

The node/controller uses the DMK Eng URI pinouts as follows:

URI  dB25                                                   Controller dB9

pin 1=ptt  ....................................................pin 7=cos in
pin 8=cos  .................................................. pin 3=PTT out
pin 19=gnd  .................................................pin 6=gnd
pin 21=mic_in (what I call Tx Audio)  .............pin 4=Tx Audio outout to
radio
pin 22=left AC (what I call Rx Audio)  ............pin 5=Rx Audio input
from radio

Any help the group can provide as to set up of RC210 and suitability of the
above settings would be appreciated.  Thanks in advance

K9CWM
csjmoore at gmail.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.hamvoip.org/pipermail/arm-allstar/attachments/20160905/3c8a6e15/attachment.html>