[arm-allstar] minicom and Rpi2

[ku6v]

Hi David

This is what I see when I check for tty devices.

 

[root at ku6v ~]# dmesg | grep tty

[    0.000000] Kernel command line: dma.dmachans=0x7f35
bcm2708_fb.fbwidth=656 bcm2708_fb.fbheight=416 bcm2709.boardrev=0xa01041
bcm2709.serial=0xe715c5b smsc95xx.macaddr=B8:27:EB:71:5C:5B
bcm2708_fb.fbswap=1 bcm2709.disk_led_gpio=47 bcm2709.disk_led_active_low=0
sdhci-bcm2708.emmc_clock_freq=250000000 vc_mem.mem_base=0x3dc00000
vc_mem.mem_size=0x3f000000  root=/dev/mmcblk0p2    rw rootwait
console=ttyAMA0,115200 console=tty1 selinux=0 plymouth.enable=0
smsc95xx.turbo_mode=N dwc_otg.lpm_enable=0 kgdboc=ttyAMA0,115200
elevator=noop

[    0.001140] console [tty1] enabled

[    1.045218] dev:f1: ttyAMA0 at MMIO 0x3f201000 (irq = 83, base_baud = 0)
is a PL011 rev3

[    1.593125] console [ttyAMA0] enabled

[    5.931747] systemd[1]: Expecting device dev-ttyAMA0.device...

[    6.204517] systemd[1]: Starting system-serial\x2dgetty.slice.

[    6.213723] systemd[1]: Created slice system-serial\x2dgetty.slice.

[    6.362936] systemd[1]: Starting system-getty.slice.

[    6.371923] systemd[1]: Created slice system-getty.slice.

[    7.683107] usb 1-1.5: pl2303 converter now attached to ttyUSB0

 

I set up minicom to connect to my rlc4 device and that is what it's looking
for now. It shows the opening minicom screen and shows as "offline" at the
bottom of the screen. It may be the modem parameters I have to change. To
what I am not sure yet or of that's it.

 

73

Don

KU6V

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.hamvoip.org/pipermail/arm-allstar/attachments/20160218/4e7cc320/attachment.html>