[arm-allstar] netctl difficulty

[AD2DX]

Ian,
Since you’re using CIDR notation as /29, are you sure you want that? I would think you want /24 or 255.255.255.0. You might want to check the subnet mask that you have specified. Also check the default gateway since they can only talk to each other on the same subnet.
Thanks and 73,
Joe AD2DX

> On May 20, 2015, at 5:21 PM, gm4upx at gb7jd.co.uk wrote:
>
> Hello,
>
> Has anyone experienced this:-
>
> I have two BBB and one PI2 and I decided that I would move them to a subnet and used the following cmds.
>
> edited /etc/netctl/eth0 on each and added the new ip addresses ( static ) ; I found that I only needed to enter the ipaddress like [192.168.1.1/29] and gateway like [192.168.1.10], this worked OK on the BBB's but the PI2 refuses to take the new addresses and using [netctl stop eth0], then [netctl start eth0] gives me an error that eth0 can't be loaded and I can't connect to anything other than the other two BBB's on the same subnet.  I have also removed the " default " settings with [ip route del 0/0 via 192.168.0.1 dev eth0] and saved the eth0 configuration but it still refuses to play ball.
>
> It should be simple to do, it works on the BBB's, but not on the PI2 and after hours of trying it just won't work for me.  All suggestions welcome..
>
> Regards,
>
> IAn..
>
>
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB web page - http://www.crompton.com/hamradio/BeagleBoneBlackAllstar/
>

This email communication and any files transmitted with it may contain confidential and or proprietary information and is provided for the use of the intended recipient only. Any review, retransmission or dissemination of this information by anyone other than the intended recipient is prohibited. If you receive this email in error, please contact the sender and delete this communication and any copies immediately. Thank you.