[arm-allstar] arm-allstar Digest, Vol 13, Issue 8

[gm4upx at gb7jd.co.uk]

Hello Doug,

You are correct; I used the simple_tune_menu to make the changes to suit 
my system and just assumed that Ken would do the same.
Sorry for the confusion, I didn't mean to say that making a manual 
change was the way to go..

Regards,

Ian..

> 
> Message: 1
> Date: Wed, 03 Jun 2015 23:03:05 +0100
> From: gm4upx at gb7jd.co.uk
> To: arm-allstar at hamvoip.org
> Subject: Re: [arm-allstar] BBB problems
> Message-ID: <88c601bf3cdb8bd95bb1457aef41d5df at gb7jd.co.uk>
> Content-Type: text/plain; charset=US-ASCII; format=flowed
> 
> Hello Ken,
> 
> You could try adjusting the parameters below if you haven't already.
> I found that I needed to " fine tune " them to accept correctly the
> tones from my Chinese HH while my Icom HH was OK with the default
> settings.
> 
> ; name=usb
> ; devicenum=1
> devstr=1-1:1.0
> rxmixerset=500
> txmixaset=500
> txmixbset=500
> 
> 
> Regards,
> 
> Ian..
> 
> 
> 
> 
> ------------------------------

> 
> Message: 4
> Date: Wed, 3 Jun 2015 21:30:13 -0400
> From: Doug Crompton <doug at crompton.com>
> To: ARM Allstar <arm-allstar at hamvoip.org>
> Subject: Re: [arm-allstar] BBB problems
> Message-ID: <BLU171-W1087D190CFA0CBA36EC46A8BAB30 at phx.gbl>
> Content-Type: text/plain; charset="iso-8859-1"
> 
> Ian,
> 
>  Those settings are the levels for RX and TX A and B and the default
> values are 500. These should be set om every system for the values
> required based on the connected radio.  You would use the
> simpleusb-tune-menu program to set the levels. 500 would be a starting
> point but since many different radios are used the values could vary
> widely. It might be fine for one system but not another. You really
> have to actually set the levels using the display in
> simpleusb-tune-menu. In addition the rx level could be changed up or
> down if needed by setting the rxboost in simpleusb.conf.
> 73 Doug
> WA3DSP
> http://www.crompton.com/hamradio
> 
>