[arm-allstar] BBB node problems

[Ken Robinson]

Hi Doug,

I can ping

 

64 bytes from ucsd.edu (132.239.180.101): icmp_seq=157 ttl=52 time=168 ms

 

Registry shows this

 

Host                  dnsmgr  Username    Perceived             Refresh
State

67.215.233.178:4569   Y       28468       151.227.213.230:1024       60
Registered

 

The results when I press the no 1 key on the radio comes back as

 

bbb-allstar*CLI>  -- Hungup 'DAHDI/pseudo-255737528'

No such command ' -- Hungup 'DAHDI/pseudo-255737528''

 

I typed simpleusb-tune-menu from the linux command and just tried it again
and it worked

I must have got it wrong 

 

I have had a node running for about four or five years from the acid setup
on my pc to running bbb vers 1 and running the raspberry pi 2 version to
without any problems. I need the raspberry for another project  which is why
I'm going back to the BBB and it's the first time I have had any problems

 

Tried various settings in simpleusb-tune-menu but no difference

 

Ken

 

 

 

From: arm-allstar-bounces at hamvoip.org
[mailto:arm-allstar-bounces at hamvoip.org] On Behalf Of Doug Crompton
Sent: 03 June 2015 17:50
To: ARM Allstar
Subject: Re: [arm-allstar] BBB node problems

 

Ken,

 It looks like the ip address is correct.  See if you can ping at the linux
prompt -  ping ucsd.edu

Also go into the client - asterisk -rvvv   and  type  iax2 show registry

and see if you are registering.

The example you gave didn't show the actual tones in the display???  It
should print the DTMF key you press.

simpleusb-tune-menu is  a linux command - not in the client.

I don't recommend usbradio on any of the small boards at this time. I am
surprised you were using it on version 1.0

Do keep in mind that simpleusb requires a COS signal from the transceiver or
receiver indicating carrier. It also has to be set properly in
simpleusb.conf   -  carrierfrom=  usb  or usbinvert    -  usb if high on
signal and usbinvert if low (0v).  If this is not set properly it will not
work or work in weird ways.

carrierfrom   works with pin 8 on the DMK-URI.   Pin 8 should go to the rigs
cos output.

This is all in the setup docs at hamvoip.org  - did you read them?

73 Doug
WA3DSP
 <http://www.crompton.com/hamradio> http://www.crompton.com/hamradio



  _____  

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.hamvoip.org/pipermail/arm-allstar/attachments/20150603/45274b3f/attachment.html>