[Arm-allstar-irlp] connection failed

[Paul - KN2R]

Hi Glenn,

You may want to check your firewall port forwarding for IRLP and make sure your rules are pointing to the IP for the new RPi.
Also be sure to follow step by step the IRLP Setup Howto document?

Paul / KN2R



-----Original Message-----
From: ARM-allstar-irlp [mailto:arm-allstar-irlp-bounces at hamvoip.org] On Behalf Of "Glenn via ARM-allstar-irlp"
Sent: Sunday, November 25, 2018 1:16 PM
To: arm-allstar-irlp at hamvoip.org
Cc: Glenn
Subject: [Arm-allstar-irlp] connection failed

Hi folks, My desktop crashed back in January. I was not going to try and fix it as the mother board was bad. So loaded up on a PI-3. Finally found a backup of the secring.pgp. Things worked fine till about 2 weeks ago I decided to make a backup copy of the MicroSD card.
Well screwed that up so now have to start over.  Now every thing works except IRLP.
  This is what I get in the IRLP log
Sun Nov 25 11:03:41 CST 2018 [irlp_fullreset] Full Reset completed.

Sun Nov 25 11:03:41 CST 2018 [connect_to_reflector] Reflector ref905/Ch-0 CODEC chosen is UNCOMP.
Sun Nov 25 11:03:42 CST 2018 [connect_to_reflector] Timeout is disabled.
Sun Nov 25 11:03:42 CST 2018 [connect_to_reflector] Node Connected to base reflector ref905/Ch-0 Sun Nov 25 11:04:06 CST 2018 [end] Node Disconnect from ref9050

I am missing something..

_______________________________________________
ARM-allstar-irlp mailing list
ARM-allstar-irlp at hamvoip.org
http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar-irlp